Breda hat is a hat type that many friends like. Generally speaking, the Beretie hat is more suitable for some mature female friends. It not only has a warmth effect, but also has a strong decorative effect. It is more fashionable with clothes. In this cold winter, it is more suitable to help your mother weave a beret. In fact, the weaving method of the beret is not difficult. Today we will learn the weaving of a basic model of simply spiral beret. It is unlimited, wool, cashmere threads, blending lines, etc. It is a blended air yarn (100g/150 meters), a 4.0mm ring needle.
We woven the hat from bottom to top. First of all, the number of pins requires the multiple of 7, demonstrating 85 stitches (about 53-55 head circumference). There is an extra needle here for the beginning of the beginning: The right needle picks the first needle of the left needle, and then the right needle is accepted forward, so the total number of needles will be turned into 84 stitches, and then the first coil of the right needle is turned back to the left needle. Then we woven the bottom edge of the monocular tattoo (that is, repeat <1 positive 1 reverse> to weave).
Then we started to knit the hat body. Before weaving, the hat was flattened into 7 copies, and we were deducted with a mark (84 stitches in total, that is, 12 stitches per port). Circle 1: Repeat (12 stitches on the right, the ferry line plus 1 needle twisted needle) woven the full circle. (Note: This needle plus the cross line must be woven into a twist needle, not to be woven into a hollow needle, refer to the icon below). Circle 2: Do not add a circle of pins (now it becomes 13 stitches).
Circle 3: Repeat (13 stitches, weaving 1 needle with 1 needle) woven circle (Note: This needle with the ferry line must be woven into a twist needle, including all the pins in the following The needle is to be knitted into a twist needle, you must not forget it). Circle 4: Do not add a circle of pins (now 14 stitches). Circle 5-14: Repeat these two circles (that is, a circle of needles, a circle without decrease), and weave, 19 stitches per part after woven in the 14th circle.
Then we continue to weave a section (about 2 cm in height, and we can depend on the situation when we weave it). Then we will start to reduce the top part of the needle. Circle 1: Repeat (17 stitches, twist pins 2 and 1) Weaving complete circle; Circle 2: Do not reduce the weaving of a circle of pins (into 18 stitches per port); Passion -positive needle, twist needle 2 and 1) Weaving a complete circle; Circle 4: Do not reduce the weaving of the positive needle (a 17th needle per portal).
Repeat the weaving method (that is, a lap of needle reduction, and the weaving of weaving in a circle) to gradually reduce the needle, and it has been reduced to 1 needle, that is, when the total number of needles is 7 stitches, and then We break the wiring and pick the remaining coil to collect the top of the hat. This simple spiral beret is completed. I believe that even novice friends can weave it. If you like it, try it!